Was, $36,329.00 $33,026.00 +gst

Rent from $66 a Day - Call now for best Deal

Offer all the popular soft serve variations from low or non-fat

ice creams to custards, yogurt and sorbet. Serve two

separate soft serve flavors, or an equal combination of both

in a twist.


Freezing Cylinder

Two, 3.4 quart (3.2 liter).

Mix Hopper

Two, 20 quart (18.9 liter). Separate hopper refrigeration (SHR)

maintains mix below 41ºF (5ºC) during Auto and Standby modes.

Indicator Lights

Digital readout displays hours since last brush cleaning to assure

product safety. Mix Low light alerts operator to add mix. Audible

alarm may be enabled to sound when mix is low. When the Mix Out

light flashes, the unit shuts down automatically to prevent damage.

Touch Screen Controls

Microprocessor touch controls are embedded in durable tempered

glass panel. Multiple languages are selectable. Viscosity is

continually measured to dispense consistent quality soft serve

desserts. Temperatures in the hoppers or freezing cylinders may be

displayed at any point of operation, in either Fahrenheit or Celsius.

Draw counter allows operator to view number of servings



During long no-use periods, the standby feature maintains safe

product temperatures in the mix hopper and freezing cylinder.



Two dedicated electrical connections are required. See the Electrical chart for

the proper electrical requirements. Manufactured to be permanently

connected. Consult your local Taylor distributor for cord & receptacle

specifications as local codes allow.

Beater Motor

Two, 1.5 HP.

Refrigeration System

Two, 9,500 BTU/hr. R404A.

Separate Hopper Refrigeration (SHR), One, 400 BTU/hr. R134a.

(BTUs may vary depending on compressor used.)

Air Cooled

Minimum 3” (76 mm) around all sides. Install the deflector provided to

prevent recirculation of warm air. Minimum air clearances must be met to

assure adequate air flow for optimum performance.

Water Cooled

Water inlet and drain connections under side of base 1/2” FPT.

10. Warranties, Indemnities and Exclusions

10.1 Apart from the warranties implied by legislation which cannot by law be excluded, the Seller gives no further warranties or representations relating to the Goods as to their condition or quality or suitability or fitness for ordinary or special use or purpose. Any warranties which would otherwise.

10.2 The warranties contained in these Conditions do not cover materials expended or utilised during or for the operation of the Goods, whether due to any fault in the Goods or otherwise.

10.3 The Buyer acknowledges that the Seller does not make any representations or warranties regarding the Goods or any matter, which are or might be relevant to the Buyer buying or selling the Goods other than the representations or warranties expressed in these conditions.

      10.4 Unless expressly provided otherwise in these Conditions

        The Seller is not liable to the Buyer in respect of loss or damage of any kind (including economic or consequential loss or damage), which arises directly or indirectly in respect of the sale, supply, or installation of the Goods.

10.5 The Seller will not remedy any defaults in the Goods while the Buyer is in default of the Contract.

10.6 The Buyer indemnifies the Seller against any liability, loss or expense arising directly or indirectly from use or operation of the Goods.


J.L.Lennard does not offer any compensation for any product loss, damage or expenses directly or indirectly arising from the use or inability to use the product or from any other cause.


Warranty is 12 months parts and labour with the purchases of new machines only. Certain components are wear items and are not covered under Warranty, for example, gaskets. See Warranty Book for full details of Warranties on machine lines.

 If you have any questions about the availiablity of an item, please contact one of our friendly team on 1300 436 665 or use our Live Chat tab below.